There Is No Doubt That You Require Peugeot 308 Key Fob

Peugeot 308 Key Fob Replacement

Peugeot's 308 might be a bit old but it's still eye-catching. It might not be the plushest car in its class but a Ford Focus or Volkswagen Golf will shield you from imperfections on the road - however, it's a comfortable and comfortable drive.

Here at Coded Car Keys we are often asked to replace peugeot 308 key fobs. No matter if the issue is ongoing or continuous these tips will help.

Water Damage

If you accidentally drop your key fob in an eddy, or it gets wet while kayaking canoeing, rafting or canyoning the fob is most likely to be damaged by water. Keep your key fob in a dry bag whenever you are outside or perform things that expose it to excessive water.

You'll also want to ensure that the fob is completely dry prior to opening it and re-using it. If you notice any odors coming from the fob, like an industrial liquid smell or windshield washer fluid, this is another indication that it's submerged in water.

A wet circuit may cause the battery's energy to drain or even explode. If you're able to pull the 308 key fob of whatever body of water it got stuck in it, flip the button side down and shake it out as much water as you can before opening the case. Remove the battery, then wipe the circuit board clean using a cotton swab that is dipped in 90 percent alcohol.

Other reasons your Peugeot 308 remote entry keyless system may not function could be due to a dead coin-cell battery or receiver module malfunction signal interference or a faulty chip. If none of these are the reason it is possible to reset the system by removing the 12 volt battery from your car for 15 mins.

Dead Coin Battery

Peugeot cars are equipped with a remote start system that allows drivers to start their car from an extended distance, which allows them to warm up or cool down the car before entering. This feature is very beneficial particularly in cold winter months. But sometimes, the remote start system ceases functioning due to a variety of reasons, like the battery in the coin is dead.

The coin-shaped battery inside the key fob can last between two and four years, based on how often it is used, the location it was purchased, and how it is used. Its use-by date is typically printed on the package or written in the manual.

If the key fob stops working after exposure to clean tap water then you must take the battery off, clean the electronic chip using a paper towel and isopropyl alcohol, and then dry it thoroughly before replacing it. In case of exposure to soapy or salty water, the chip could be fried and you will require replacing the key fob in total.

If you're unsure if the battery is faulty You can test the voltage with an instrument set to the car's voltage range, and connect it to the plus and minus terminals. If the voltage is less than 12-13 volts you should replace the battery. If you want to, you can attempt to reset the onboard computer by disconnecting the 12 volt battery for a short period of time, and reconnecting it in reverse order (positive cable first and then negative). The engine should begin to run after this.

Faulty Receiver Module

If you don't see "Key Detected", it could be that your receiver module is defective. It's the part that transmits an alert to the car when the key fob is activated which also acts as an immobiliser. It stops it from starting unless the correct key is present.

This could result from a variety of reasons, including water damage or simply ageing. If the chip inside your Peugeot 308 keyfob is damaged by dirty tap water, it could be because the keyfob was contaminated with it. In this situation you'll have to take the unit apart and clean it thoroughly with isopropyl alcohol or electronic cleaner. When the battery is clean, you can try again.

If the issue persists, it is a good idea to see an area Peugeot expert or locksmith. They'll use a diagnostic tool to help pinpoint the issue and repair it for you.

Losing your Peugeot keys to your car is a stressful experience. A certified auto locksmith can resolve the issue within minutes. They can cut a brand new key and programme it to your vehicle, so you can get back on the road again as fast as you can. Click here to find a local locksmith near you.

Faulty Electronic Chip

The chip in the Peugeot 308 key fob is a critical function in the remote control system. If it becomes damaged, your car may not start or you may receive a message that reads "anti-theft active". If this occurs, the only way to fix the issue is to replace the key. Fortunately, auto locksmiths with experience can provide the service in the shortest amount of time.

The chip inside the key fob of your Peugeot 308 could fail due to various reasons, such as sweat, water damage, or dirt. If your Peugeot key fob was exposed to soapy or dirty water, it should be cleaned right away. You can wipe the electronic component using a paper towel soaked in isopropyl Alcohol. The battery should be allowed to dry completely.

Radio interference can cause a key fob to cease working. This can be caused by other devices operating at the same frequency as your Peugeot key fob. It could be caused by problems with the environment or objects near to the vehicle. It is recommended to visit a peugeot expert key fob dealer if you encounter this issue.

The Peugeot key fob 207/308 is extremely delicate and requires care. It should not be dropped or throw it around. If you lose it, try to locate it as quickly as you can. You can reset all on-board computers by disconnecting the 12 volt battery for a short period of time. Make sure you disconnect the negative cable first, then the positive.